Chapter 19
1. A. To disable Layer 2 functionality on a Cisco Nexus Switch you must use a routed interface, which is enabled by the no switchport command.
2. B. To add an interface to a VLAN you use the command switchport access vlan vlan number.
3. B. To add an IP address to an SVI, you enter interface configuration mode using the interface vlan vlan number command. Then enter the ip address command with the address and mask.
4. C. You would see Interface VLAN in the routing table as a connected/direct route.
5. D. You do not need the next hop router’s subnet mask to configure a static route to that router.
6. D. To configure a static route you must use the ip route statement followed by the route subnet and mask and either the outgoing interface ...
Get CCNA Data Center DCICN 640-911 Official Cert Guide now with the O’Reilly learning platform.
O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.
