Chapter 8 OSPF

Lab 8-1: Advertising Networks

image

Figure 8-1 Advertising Networks

Figure 8-1 illustrates the topology that will used in the following tasks.

Task 1

Configure the connections between R4, R5, and R6 and run OSPF Area 0 on the f0/0 and the lo0 interfaces of these three routers. Configure the router IDs to be 0.0.0.x, where x is the router number. The loopback interfaces should be advertised with their correct mask.

Click here to view code image

On SW1: SW1(config)# interface range FastEthernet0/4-6 SW1(config-if-range)# switchport SW1(config-if-range)# switchport mode access SW1(config-if-range)# switchport access vlan 456 SW1(config-if-range)# ...

Get CCIE Routing and Switching v5.1 Foundations: Bridging the Gap Between CCNP and CCIE now with the O’Reilly learning platform.

O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.

Start your free trial