CCIE Routing and Switching Practice Labs

Section 1: Bridging and Switching (18 Points)

Section 1.1: Frame Relay Configuration (3 Points)

• Configure the Frame Relay portion of the network as shown in Figure 5-8 and ensure that only the PVCs illustrated in Figure 5-8 will be used. Use of dynamic PVCs is not permitted.

  Figure 5-8. Frame Relay Diagram

  

• You must use subinterfaces on R2 interface s0/1.

• Do not configure subinterfaces on any other routers.

• You must be able to ping across the Frame Relay cloud.

Section 1.2: 3550 LAN Switch Configuration (12 Points)

• Sw1 and Sw2 are connected via a crossover cable using ports fa0/15. Configure a Dot1q (801.1Q) trunk between Sw1 and Sw2.

• All Ethernet ports ...